Pc-Check Windows Location Test Failure Information

Group 180X

Device Location

The location functionality is provided by one of a number of sensors including Global Positioning System.

Test Name 303

Location

This test has an non-interactive and an interactive test mode. In the non-interactive variant, the correct longitude and latitude require being set within a given tolerance value. The interactive test shows a map of the world and the identified geographic location using an icon. The Operator then selects pass or fail depending on the identified geographic location. Two general types of location sensors are present in systems, they can be either a physical Global Positioning System sensor or a triangulation device. In a physical Global Positioning System sensor, line of sight with satellites is expected to initialize the test. In an enumerated location sensor (Such as Windows Location Provider) a working wireless connection is required to find the location.

Estimated Test Time 1 Second for the non interactive test. Interactive test time would depend on the time-out parameter given by the operator.

PARAM1: Time-out

Test time-out.

PARAM2: Latitude Value

Latitude.

PARAM3: Longitude Value

Longitude.

PARAM4: Location Tolerance - latitude

Latitude tolerance in percent.

PARAM5: Location Tolerance - longitude

Longitude tolerance in percent.

ERRORCODES & TROUBLESHOOTING

The sensor was not found. CODE="0x00/3FF"

TROUBLESHOOTING0: The sensor was not detected. This could be caused by faulty drivers or a loose connection.

The sensor failed to start. CODE="0x01/3FF"

TROUBLESHOOTING0: The sensor was not detected. This could be caused by faulty drivers or a loose connection.

Access to the sensor was denied. CODE="0x02/3FF"

TROUBLESHOOTING0: The sensor was not detected. This could be caused by faulty drivers or a loose connection.

The sensor has encountered an error. CODE="0x03/3FF"

TROUBLESHOOTING0: The sensor was not detected. This could be caused by faulty drivers or a loose connection.

The sensor is in an unknown state. CODE="0x04/097"

TROUBLESHOOTING0: The sensor was not detected. This could be caused by faulty drivers or a loose connection.

Unable to create test window. CODE="0x05/001"

TROUBLESHOOTING1: Creation of the interactive window failed or the test timed out. Most likely a an operating issue.

The test timed out. CODE="0x06/3FF"

TROUBLESHOOTING1: Creation of the interactive window failed or the test timed out. Most likely a an operating issue.

The Operator chose to fail the test. CODE="0x07/3FF"

TROUBLESHOOTING2: The interactive test failed since the operator cancelled the test. Please consult the operator for more information.

Required bitmaps are missing. CODE="0x08/3FF"

TROUBLESHOOTING3: Required bitmap resources are missing.

The location read is outside of tolerance. CODE="0x09/3FF"

TROUBLESHOOTING4: The location from the sensor is outside of the tolerance for the test. This may be caused by a faulty sensor, issue reading the location or an incorrect test parameter. If the sensor type is Global Positioning System, then line of sight is required. If the sensor type is triangulation using wireless, signal strength should be confirmed.