Pc-Check Windows Location Core Recognition Test Failure Information

Group 180X

Device Location

The location functionality is provided by one of a number of sensors including Global Positioning System.

Test Name 301

Core Recognition

The Core Recognition test checks the location device to ensure it is connected and detected properly.

Estimated Test Time 1 Second.

ERRORCODES & TROUBLESHOOTING

The sensor was not found. CODE="0x00/3FF"

TROUBLESHOOTING0: The sensor was not detected. This could be caused by faulty drivers or a loose connection.

The sensor failed to start. CODE="0x01/3FF"

TROUBLESHOOTING0: The sensor was not detected. This could be caused by faulty drivers or a loose connection.

Access to the sensor was denied. CODE="0x02/3FF"

TROUBLESHOOTING0: The sensor was not detected. This could be caused by faulty drivers or a loose connection.

The sensor has encountered an error. CODE="0x03/3FF"

TROUBLESHOOTING0: The sensor was not detected. This could be caused by faulty drivers or a loose connection.

The sensor is in an unknown state. CODE="0x04/097"

TROUBLESHOOTING0: The sensor was not detected. This could be caused by faulty drivers or a loose connection.

Unable to create test window. CODE="0x05/001"

TROUBLESHOOTING1: Creation of the interactive window failed or the test timed out. Most likely a an operating issue.

The test timed out. CODE="0x06/3FF"

TROUBLESHOOTING1: Creation of the interactive window failed or the test timed out. Most likely a an operating issue.

The Operator chose to fail the test. CODE="0x07/3FF"

TROUBLESHOOTING2: The interactive test failed since the operator cancelled the test. Please consult the operator for more information.

Required bitmaps are missing. CODE="0x08/3FF"

TROUBLESHOOTING3: Required bitmap resources are missing.

The location read is outside of tolerance. CODE="0x09/3FF"

TROUBLESHOOTING4: The location from the sensor is outside of the tolerance for the test. This may be caused by a faulty sensor, issue reading the location or an incorrect test parameter. If the sensor type is Global Positioning System, then line of sight is required. If the sensor type is triangulation using wireless, signal strength should be confirmed.